Y10S277/00 - CPC Classification

Seal for a joint or juncture

• Y10S277/902 » Seal for sterling engine 0
• Y10S277/903 » Seal for rotating kiln or drum 6
• Y10S277/904 » Viscous seal 2
• Y10S277/905 » T-Shaped or I-shaped ring member including seal on a side 2
• Y10S277/906 » Seal for article of indefinite length, e.g. strip, sheet 1
• Y10S277/907 » Passageway in rod or shaft 4
• Y10S277/908 » Seal for use in rotating and reciprocating arrangement 2
• Y10S277/909 » Similar sealing structures for mounting on piston and about rod 1
• Y10S277/91 » O-ring seal 19
• Y10S277/911 » Seal combined with nominal motion transmitting device 2
• Y10S277/913 » Seal for fluid pressure below atmospheric, e.g. vacuum 8
• Y10S277/914 » Backup seal for failure of primary seal 6
• Y10S277/915 » Seal including compression set feature 2
• Y10S277/916 » Seal including vibration dampening feature 6
• Y10S277/917 » Seal including frangible feature 4
• Y10S277/918 » Seal combined with filter or fluid separator 8
• Y10S277/919 » Seal including electrical feature 13
• Y10S277/92 » Seal including electromagnetic shielding feature 33
• Y10S277/921 » Closure or weather strip seal 63
• Y10S277/922 » Bonding or joining for manufacture of seal 2
• Y10S277/924 » Deformation, material removal, or molding for manufacture of seal 5
• Y10S277/925 » Snap fit feature for mounting or assembly of seal 3
• Y10S277/926 » Seal including fluid pressure equalizing or balancing feature 10
• Y10S277/927 » Seal including fluid pressure differential feature 4
• Y10S277/928 » Seal including pressure relief or vent feature 24
• Y10S277/929 » Seal feature where change in operation or condition induces additional leakage control 0
• Y10S277/93 » Seal including heating or cooling feature 9
• Y10S277/931 » Seal including temperature responsive feature 4
• Y10S277/934 » Seal swells when wet 17
• Y10S277/935 » Seal made of a particular material 2